Ốp Seeed Wio Tracker L1 E-ink kèm Display Protector

This is a remix based on the Seeed Wio Tracker L1 e-ink Case by zeropt and Frey.

Protection over Readability. My remix offers to print a display protector in place. The display get a little bit blurried out, but depending on how good you are able to print the translucent material. My .3mf file is designed to print in PETG. Just use the predefined settings.

Furthermore you can use 2x M2 thread inserts to mount the backplate linked down below. If you dont like to use thread inserts, just remove the two cylinders as negative parts.

Recommended: This nice backplate keeps the board and the battery separated from each other. It offers space for the antenna cable by a cut. Quite enough to print it with only 0.4 mm thickness.
https://makerworld.com/de/models/2332112-wio-tracker-l1-oled-case-3000mah#profileId-2548106