
PEZ-Blaster (súng PEZ lò xo)
- Downloads
- 5
- Likes
- 1
- Views
- 73
- Remixes
- 0
- Comments
- 0
Files 8 3.1 MB
- pg-Hammer_1778667284.3mf3MF · 34.2 KB
- pg-Sender14mm_1778667285.3mf3MF · 5.9 KB
- pg-Left_Half_1778667285.3mf3MF · 116.9 KB
- Sledge_1778667286.3mf3MF · 72.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #383183
- Category
- Đồ Chơi Khác
- Published
- License
- GNU General Public License v3.0
Description
Use this thing AT YOUR OWN RESPONSIBILITY!!!
Assembly requires two springs and some silicon grease. Rear spring is in my case 0.7x7x30mmx10.5n (compressive). Front spring can be a spring from a ball-point-pen (if it has many windings).
The two halves are hold together using 3 m3 thread inserts with screws (10mm thread).
Front spring must be mounted on the screw at the barrel's end and on the trigger.
The magazine is a regular PEZ-dispenser with the head ripped off and some additional cuts (see photo).
For printing: PLA works fine with 0.4mm nozzle diameter.
Use this thing AT YOUR OWN RESPONSIBILITY!!!
Print spec
- Formats
- 3mffcstd
- Model files
- 8
- Total size
- 3.1 MB
- Largest file
- 2.5 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-

-

-

-

-


