Skip to main content
F3D
Bộ kẹp gọn dây nguồn cho Pedal Board 1

3 images

DIY

Bộ kẹp gọn dây nguồn cho Pedal Board

By _3883847

Downloads
1
Likes
1
Views
54

Files 2 101.8 KB

  • clamp_v2.1_1778653600.3mf3MF · 43.7 KB
  • clamp_v2.1_1778653601.stlSTL · 58.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Designed for players frequently re-organizing their signal chain.
Can be used to route the power cables where they need to go and hold the extra slack in place.
Snug fit - the cables are held in a tight grip, will not fall out due to shaking or vibration.
For best results, put the cable into the top of the holder by spreading the 'lips' with your fingers, and then push the cable down using a guitar pick.
Length = 50 mm
Width = 20 mm
Height = 20 mm
Recommended clearance between the floor and the bottom of the underside of the board = 25mm or more
Designed to be mounted using two M3 x 16 wood screws. If your board is made of metal, use some good double-sided tape instead.

Read more Show less

Print spec

Formats
3mfstl
Model files
2
Total size
101.8 KB
Largest file
58.1 KB

0 comments

See all