Bộ Riser cho Creality K2 CFS kèm giá đỡ nắp máy

I wanted a riser to lift my CFS up so I could remove the lid when printing, I had the idea of adding a flip paddle to each riser that would allow the lid to lift up and latch in place. 

The lid can be tilted at the front, rear or both, the paddle can be pushed back in to allow the lid back down or the lid can slide out fully and slide back into place on top of the printer frame. 

The riser has provision for a captive M4 nut, the bolt goes through the shelf into the riser. 

Instead of using a spring to make the flipper stay out I used two magnest opposing each other, one in the riser body and the other in the flipper.

I printed them out of Sunlu PLA+ 2.0 and I printed them on their side with supports to give best strength.