Nhím đất 3D do học sinh Cooper thiết kế

This porcupine was designed by Cooper, one of my students. Coop's a very talented fifth-grade artist. He designed this critter in about an hour from start to finish.

You'll obviously need a dual extruder printer in order to make one of these for yourself.

Instructions

The porcupine shown in this picture was printed on an old FlashForge Creator dual extruder printer using ABS at 230. The hot end of this printer is pretty well shot, which is why there is so much extra plastic and rough edges. Also note that the tops of its ears are slightly truncated. I'll print another and update the imagery after I swap out the extruders.