High Priestess

This is one of many model's/statues i have created in blender for a project i am working on. Uploaded here because i don't think it will be using this one in my project and someone might get some use out of it.

Although i did not 3D print this one the other 6 i have printed so far have come out fine on my Elegoo Centauri Carbon 

I printed the others in both PLA and PETG PLA gave me a cleaner look for painting

0.4 nozzle 

0.2 layer hight

0.42 line width

15% infill

I used tree supports on my others would recommend having them on bed only can be a pain clearing them off the model itself sometimes be careful with the sword  too i had a problem with one not printing and snapping off on another model ended up redesigning so it was at an angle.

I resized the others in the slicer to 150mm but i am sure if you wanted too it would go smaller or larger.

Any problems give me shout and i will see if it can be fixed 

Enjoy the Model the printing and painting if you wish to do so.