Skip to main content
F3D
Tượng Bust Hươu Patronus (Stag) — Đế Treo Nhẫn 1

10 images

Đồ Gia Dụng

Tượng Bust Hươu Patronus (Stag) — Đế Treo Nhẫn

By Jazzphone

Downloads
2
Likes
1
Views
61

Files 2 22.6 MB

  • patronus_stag_1778347599.stlSTL · 11.3 MB
  • patronus_stag_1778347601.stlSTL · 11.3 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#380502
Category
Đồ Gia Dụng
Published

Description

A stylized stag bust on a round pedestal — head and shoulders only,

antlers raised. Each antler has 4 thick tines angled upward at 50–75°

from horizontal so jewelry rings slide down the tine and rest at its

base. Built with chunky beams and no fragile spikes; the whole piece

prints solidly.

  • 70 mm pedestal, ~120–140 mm tall depending on antler reach

  • - Single solid, flat bottom — prints upright, NO supports

  • - Holds a stack of rings on each tine; smaller rings slide further

  • - Doubles as a desk decoration when not in use

Print notes:

  • 0.2 mm layer, 15–20 % infill is plenty

  • - Silk PLA looks great on the antlers (the photo is silk metallic blue)

  • - Light stringing between antler tines is normal — quick wipe with a

  •   hot-air gun cleans it up

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
22.6 MB
Largest file
11.3 MB

0 comments

See all