Huntrix Wand Single Piece Remix

This merged model defaults to 410.87mm (16.17") in my slicer, but can be scaled up or down.

After first test print (pictured in AnyCubic PLA+), I would recommend printing this upside-down, as that appeared to use 20% - 30% less filament overall. With careful layout, I managed to fit seven on the same build plate (model scaled to fit vertical on 256^3); 3MF for that is attached here.

Printing this tilted on 256^3 will net a piece approximately 13" tall based on my quick testing in the slicer, but note that gradients would be angled as well, which is not the aesthetic I'm after.

Please post example prints!