Skip to main content
F3D
Ngàm/holder Sunlu S1 treo Centauri Carbon phong cách Art De… 1

3 images

Máy In 3D

Ngàm/holder Sunlu S1 treo Centauri Carbon phong cách Art Deco

Remix of Giá Đỡ Máy Sấy Sunlu S1 Cho Elegoo Centauri Carbon By ToxicMedz_1716447

By Kev_463734

Downloads
19
Likes
5
Views
160

Files 2 871.7 KB

  • Sunlu_S1_Centauri_Carbon_Semi-Circular_Mount_1778337414.stlSTL · 547.4 KB
  • lock_1778337415.stlSTL · 324.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This holder lets you lift your Sunlu S1 off the desk/table/whatever and suspend it on the CC itself.

I couldn't find one I liked online, but I took inspiration from one I found and started again with a new model.

My version:

  • can be printed as a single job on a Centauri Carbon

  • streamlines the overall shape into a more elegant and minimal semi-circle

  • lowers the position slightly, so you have maximum clearance above

  • includes an outlet for the filament to feed into a bowden tube directly from the dryer

To use it effectively, you'll probably want to add a bowden tube between the S1 and the runout sensor, and one of the tube attachment covers for the sensor. You can see this is one of the photos.

I bought a couple of PC4-M10 push-fit connectors and a Creality replacement tube from Temu, but there are no end of similar products out there, and this is optional of course.

After mounting it, I also found that the position of the runout sensor is a nuisance, meaning you can't really open the S1 while it's in this mount as the sensor sticks out too far from the CC. I removed the sensor mount and will probably just stick it back to the casing with some double sided tape. I may make a replacement back panel for that sensor too, so it sits flush. I'll try to add it here if I do. You can find other options for relocating it on 3D sites.

Since I have just ordered the new Canvas unit, I probably won't use this for long myself and so I probably won't be making other tweaks. If anybody wants to, I can see a few very minor improvements:

  • You could mount a couple of magnets to increase the friction with the CC. It doesn't really move in practice, but I guess this would make it even more stable

  • I didn't notice the feet overlap my bottom plate, which lifts the back by about 2mm. You could cut a small recess for them

  • I didn't think about the fact that the Sunlu case actually tapers towards the bottom (so they can get it out of their mould I expect, so this mount could be narrowed about 3mm towards the bottom to get an even more snug fit.

When printing, you can orient it however you prefer - it fits in any orientation. You can probably use the least support material if you print it on the back panel (as I did since my filament was running low) but maybe nicer to print with the front on the plate instead. (And I used the wrong filament profile so you can see a slightly poor finish in the photos - my fault, not the model's).

I printed in PETG with 3 or 4 walls and only 10% gyroid fill and it seems plenty strong enough.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
871.7 KB
Largest file
547.4 KB

0 comments

See all