Giá đỡ bình xịt sử dụng với thanh 10mm

• print 1x left side and 1x right side
• cut any 10mm rod to length of your choice
• if needed, use glue to secure the rod on both ends
• to fit use 4pcs of 4mm self tapping countersunk screws

Printing instructions:

• max layer height 0.2mm to keep the overhangs clean
• 4 perimeters
• no supports at 0.2mm layer height needed
• USE brim if printing from PLA to keep bed adhesion OK

Version history:

v1.0
6.10.2023

• initial release