
Rope Winder + (Bộ cuốn dây kèm dao cắt)
- Downloads
- 38
- Likes
- 21
- Views
- 270
- Remixes
- 0
- Comments
- 0
Files 5 439.8 KB
- RopeWinder_1778207886.stlSTL · 132.2 KB
- RopeWinder_bladeCover_1778207888.stlSTL · 10.6 KB
- RopeWinder_noSupport_1778207889.stlSTL · 128.7 KB
- RopeWinder_noSupport2_1778207890.stlSTL · 115.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #377817
- Category
- Thể Thao & Ngoài Trời
- Published
Description
This little rope buddy has a few features that put it a cut above other rope winders.
-
Firstly, it includes a ropecutter (18mm snap blade)
-
Opposite the cutter is a carbiner loop for hanging it off gear
-
Below the rope cutter is a 4mm hole for securing the end before you start winding
-
Below that is a space for winding, it's also sized to hold duct tape if you carry that
-
Lastly, at the bottom, are several holes for tieing off your rope when it's wound
-
Each of the 4mm holes has a notch for smaller thread like dyneema or kevlar thread
It's a small winder for hiking, camping, or outdoor adventures.
Holds up to 50 feet (15.24 meters) of 4mm rope.
You will need 2 M3 bolts to attach the 18mm snap blade cover
UPDATE:
I got tired of winidng 100 feet of kevlar thread by hand... so I made a drill attachment.
Keep in mind the layers while printing, I recomend orienting it on the thin edge, and using supports, so it doesn't snap while winding (as shown) -->
Go slow, and keep some tension on the thread as you guide it while it winds... it's much more fun with this lil guy.
If you need a bigger one, or a lighter stuffed in the bottom, check out the XL version:
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 439.8 KB
- Largest file
- 132.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-


