Ngàm nam châm Philips Hue Dimmer cho GIRA System 55

Description

This remix uses the original magnets from the dimmer mount to hold the dimmer securely in place while keeping it fully removable.

Before removing the magnets, their positions were carefully marked so they can be reinserted accurately into this model. The design is made for 15 × 2 mm magnets.

The result is a simple and reliable mounting solution without the need for additional clips or complex mechanisms.

---

Base Model / Concept

This model is based on an adapter for the Philips Hue Dimmer Switch, designed to fit into a GIRA System 55 double frame without a center bridge, giving you the clean “GIRA look” without buying an expensive Friends of Hue switch.

You can mount the adapter:

• using screws through the frame

• or with strong double-sided tape

---

Compatibility

⚠ This version is designed only for GIRA System 55 (Standard 55) frames.

It may work with other System 55 compatible frames, but fit and thickness can vary depending on the manufacturer.

---

Print Profiles

There are multiple print profiles included:

• All profiles pause the print at the correct height to allow inserting the magnets during printing

• Make sure the magnets are inserted with the correct polarity (SN/NS orientation) — the same orientation as in the original mount is required for proper function

One of the profiles uses a dual-material setup:

• PLA for the main part

• PETG only at the support interface

This combination results in a very clean surface finish, especially on supported areas.

---

Notes

• Magnet positions must match the original layout for proper hold

• Check polarity carefully before resuming the print

• Lightweight design – adhesive mounting is possible

• Easy to modify if needed