Khay nhả pin AAA-AA (print-in-place)

Remex of SJBuilds's "AAA-AA battery dispenser". No screws, no adhesives, print-in-place with Imoto's 3D-print-perfect-bridge technique. Also, make the whole unit lower and compact. I truly appreciate SJBuilds for publicly sharing a nice model with an open-source license (CC-Attribution).

Printing procedure

1. This model uses Imoto’s 3D-print-perfect-bridge technique; you should print the _bridge shee_t first.

2. Wait until the printed bridge sheet has cooled down to room temperature.

3. Carefully peel the sheet off the print bed. If the sheet is bent, please print it again. Sheet flatness is critical to the final print quality of the battery dispenser.

4. Start printing the battery dispenser.

5. When the printing pauses, insert the AAA bridge sheet (the smaller one) into the groove. Please check and confirm whether the AAA bridge sheet is correctly placed in the groove.

6. Clean the print head with a brush, then resume printing.

7. When the printing pauses again, insert the AA bridge sheet (the larger one) into the groove. Please check and confirm whether the AA bridge sheet is correctly placed in the groove.

8. Clean the print head with a brush, then resume printing.

Window

Due to the technique, the window showing the number of batteries is only available on one side. By default, the window appears on the right-hand side, but if you prefer it on the left, please use the files with 'LeftWindow'.