Skip to main content
F3D
Vỏ đạn MEGA-XL bản thu nhỏ (ID=29,9mm) --- MEGA-XL Silly Sh… 1

2 images

Đồ Chơi Ngoài Trời

Vỏ đạn MEGA-XL bản thu nhỏ (ID=29,9mm) --- MEGA-XL Silly Shell

Remix of Silly Shells: Vỏ đạn shotgun in 3D cho súng Nerf tự chế By Sillybutts

By Corvus_1914958

Downloads
58
Likes
12
Views
314
Remixes
1

Files 1 3.7 MB

  • MEGA-XL_SillyShell_Narrow_1778131846.stlSTL · 3.7 MB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

Narrower --- MEGA-XL Silly Shell

My new MEGA XL darts slipped out of the original shells when I held them upside down. 
Since the standard Mega XL shell was too loose for my darts (brand-new original Nerf MEGA-XL Darts) I built a narrower one. 
(Apparently there are relatively strong deviations in foam with the Mega XL Darts)

I reduced the inner diameter from 30.6mm to 29.9mm with flat and smooth inner barrel walls without retaining “ribs”. 
This way, my MXL darts sit securely in the shell, and the FPS is also significantly improved.

The Anenome shoots MEGA-XL up to 74 FPS with this shell.

-------------------------------------------------------------------

The file is already pre-oriented.

Print settings (the same settings as for the other Silly Shells):
0,2mm layer height
at least 5 walls
20% gyroid infill
at least 7 top and bottom shell layers

NO supports needed

Sillybutts recommends 100% infill for the first 13mm of the Silly Shells. 

As with all printed barrels, it is always a very good idea to sand the inside of the barrels to smooth it out a bit.

Thanks to Sillybutts for the files I could use for this remix.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
3.7 MB
Largest file
3.7 MB

0 comments

See all