Skip to main content
F3D
Pasta Press – Khuôn ép pasta kèm dao cắt 1

3 images

Đồ Gia Dụng

Pasta Press – Khuôn ép pasta kèm dao cắt

By mmOne

Downloads
4,753
Likes
1,422
Views
19,145

Files 14 2 MB

  • shell-a_1777825957.3mf3MF · 212.5 KB
  • shell-b_1777825958.3mf3MF · 191.6 KB
  • hinge-a-l_1777825959.3mf3MF · 8.1 KB
  • hinge-a-r_1777825960.3mf3MF · 8.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a pasta press with the accompanying cutter. It creates pasta with ca. 75mm diameter.

Printing

Nothing out of the ordinary. Print the parts as they are oriented in the file. I would recommend printing the hinge parts solid with five perimeters. No support required for any part by design.

Assembly

Assemble as show in the exploded-view diagram. The hinge-part with the short tab goes into the narrower shell. The hinges are a tight fit by design you can use a tabletop to press them in. 

As an axle use a piece of filament. If necessary you can prevent the axis from sliding out by cutting them a little longer quickly heat up the outer ends with a lighter and flatten them.

Food safety

You will have to make your own judgement concerning this, and there can be lengthy debates had about it. For me personally there is no issue in this case. I print in PLA and do scrub the surfaces thoroughly with soapy water before every use. There are no solvents like alcohols or fat in the dough that could extract contaminants from the plastic, should there be any, and there is no abrasion happening.

If you find this useful consider leaving a tip.

Happy printing & Buon appetito

Read more Show less

Print spec

Formats
3mfstl
Model files
14
Total size
2 MB
Largest file
667.4 KB

0 comments

See all