Skip to main content
F3D
Hộp đựng kim móc len (Crochet Hook Storage Box #1) 1

11 images

DIY

Hộp đựng kim móc len (Crochet Hook Storage Box #1)

By SteveS42

Downloads
261
Likes
117
Views
3,174
Remixes
1

Files 12 8.6 MB

  • box_v4_1777817106.stlSTL · 369.9 KB
  • clips_large_v2_1777817107.stlSTL · 783.1 KB
  • clips_small_v4_1777817109.stlSTL · 781.6 KB
  • latch_v5_1777817110.stlSTL · 276 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

My wife crochets and knits. She has a lot of needles and hooks. When I first started 3D printing, I wanted things to design and make. So, I designed this about 4 years ago as my first box project.

It uses filament for a hinge - which has been sturdy enough after plenty of use. Most people seem to use a soldering iron to slightly melt the filament ends. I prefer to use a butane torch to heat an old putty knife in one small area for 3-5 seconds - I find it easier to control and doesn't burn the filament.

In this early design, I had not yet discovered components; so it uses separate files. As a benefit, the latch and clip inserts are easily replaceable. My wife has foam pushed onto her hooks, so that is what drove the size of the "U" shaped clips. If your hooks are different size, it should be easy enough to change the dimension of the clips.

The box halves are identical so print 2 of them. To assemble, lightly bow the clips to fit inside the little slots in the main box. The latch just snaps on.

Read more Show less

Print spec

Formats
f3dgcodestl
Model files
12
Total size
8.6 MB
Largest file
1.7 MB

0 comments

See all