Marvel Champions - Holder 3x Basic Stat Token

What is this

This is a simple little tool that I made for my Basic Stat Tokens. When playing Spider-Woman or Adam Warlock, I found it a bit tedious to flip each of the +1 basic stat tokens one by one. So I made a holder that can hold one of each type of basic stat token, allowing me to flip the tokens in sets of three.

Now, whenever Spider-Woman's ability triggers, instead of trying to remember to add 1 to each basic bower or using single tokens, I just put the token holder next to her hero card.

And by printing the holders in different colors, it's even possible to track which aspect has already been played to trigger the ability. In the picture above an aggression card and a leadership card have already been played.

How to print

Very straight forward. If you don't care about the white outline, just load the model into your slicer, hit print, and grab a coffee. And if you want the outline, add a manual filament change at 2.8 mm (or for the last four layers, when printing at 0.2 mm layer height).

If the print turns out too small for the tokens too fit (see below), scale the holder a tiny bit up in X and Y. I included a small test model which you can use to find the right scaling factor.

How to assemble

Assembly is very simple: Just press the tokens in the indentations with a little force and the tokens should stay in place. If the token falls out again, the clearance between indentation and token is too big. In that case use a bit of glue or print a rescaled holder. 

Misc

Please let me know what you think. Also, do feel free to drop me a message, if you have problems with printing these or if you have ideas for add-ons or for how to improve the design.

All my models are free and may be used and shared by everyone. I put a lot of time in my designs to get everything right and I hope the result shows. So, if you like my stuff, consider supporting me here: paypal.me/schnelge.

Cheers! ^_^