Vỏ Extruder cho Elegoo Neptune 3 /Plus/Max

This is a Extruder-Housing mod for the Elegoo Neptune 3 printers.

I wanted to mod my Neptune 3's with nicer colors and first out is the Extruder Housing.

-I would very much appreciate if you guys and gals liked my work If you enjoy the files, as it takes a lot of time to make them. ♥

This is a work in progress!

Currently we're at Version 2.

So changes will happen eventually, But fear not! In this state it is fully functioning and looks great! I've been printing with it for quite some time and it works as well as the stock one. Although, use it on your own risk depending on materials you use.

I am providing both the housing and the “Fan-mount”. Though the fan mount isnt necessery. The Housing fits super well with the standard Fan-mount that comes with the printer.

So how do one go about to change the housing?

• The housing is attached in 2 screws, one on each side, well visible just by looking at the extruder head.
• Next you can pull the housing outward and angle it down, take care for the fan-cables, and when pulling them out beware! Hold with pliers on the connector on the board and then pull the contact or else it may loosen from the mainboard. This could be a little bit fiddly.

• Next you need to take out the fan-mount and this is held in place by 4 screws.

• And for assembly just do what you just did but backwards :D

I am printing this with the following settings:

Speed: 70mm/s

Walls: 2

Infill: 25% Gyroid

Treesupport

Support interface: On

Support interface Thickness: 1,5mm

Support interface density: 80%

Print Orientation: Upright as it sits on the machine.

So go and download the file and make it in all sorts of crazy colors! Let me see em!