Skip to main content
F3D
Ngàm gắn Multiboard thay thế (WIP) - Kẹp treo thước dây 1

3 images

Đồ Gia Dụng

Ngàm gắn Multiboard thay thế (WIP) - Kẹp treo thước dây

Remix of HSW Ez-H Series Khay Đựng Đồ - Tường Lưới Tổ Ong By KYZ_446301

By Nigel_Tufnel_739863

Downloads
211
Likes
29
Views
1,574

Files 4 702.3 KB

  • Alternative_mount_v1_1777806342.stepSTEP · 118.5 KB
  • Locking_pin_1777806343.stepSTEP · 42.9 KB
  • Multiboard_-_tape_measure_-_alternate_mount_1777806344.stlSTL · 494.5 KB
  • Locking_pin_1777806345.stlSTL · 46.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#370563
Category
Đồ Gia Dụng
Published

Description

Strongly inspired by the mounting system developed by KYZ Designs for the Honeycomb storage wall.

I found trying to figure out which mount would be best for remixing hard, and loved the KYZ options for my HSW stuff, so figured I'd try to do the same for the multiboard.

Basically the mount should just press right in. But it might come out if too much down or side force is applied. So add the locking pin to hold it in there tight. At least with my print settings it is held in super tight, but might differ depending on your tolerances.

As an initial test I have made a tape measure holder (it's one of the first things in the HSW tiles i'm replacing with multiboard. But I will add more if this works better than the remix option that multiboard are putting out ‘soon’.

Read more Show less

Print spec

Formats
stepstl
Model files
4
Total size
702.3 KB
Largest file
494.5 KB

0 comments

See all