Vỏ công tắc Rocker Switch Housing

This is a switch housing I designed really quickly in Tinkercad. It's housing the switch to my auxiliary lights on my truck. I did not want to drill any holes in my truck, the lights are 100% non-permanent mounted.

Print on fully flat rectangular surface with supports. Holds the switch for NiLight wiring harness. Rocker hole is 22mm in diameter (.866 inches).

PLA will get soft in the heat of a car during summer, when this happens I will re-print in eSun tough resin

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

.12

Infill:

30%

Filament: Leapfrog PLA Gray

Category: 3D Printing