Vỏ bọc SmartPID cho Guten 70l

m3x15 button bolts w 2 washers & 1 nut, for outer holes

m3x40 button bolts w 4 washers & 3 nuts, for center holes

Remove rubber feet from SmartPID and align bracket so that protrusions fit where rubber feet were.

The PID is designed to pressure fit into the faceplate and use the the two extra nuts on center bolts to lock in place. The last nut on the center bolts locks the faceplate to the Guten

I added some silicon:

• between faceplate and guten SS
• around bolts
• at interface of SmartPID and faceplate

FDM

Use ABS or another temp tolerant plastic and orient face up with outer edges touching the build plate. Use supports

RESIN

"Sirya Sculpt" resin works well and can handle temps >100C. Use attached resin STL with supports already added

Model is available publically at Onshape

Category: Engineering