Bàn phụ (Side table) 3 chân tuỳ chỉnh

Supplies you need:

• Table top 1 pc
• Table leg ⌀21 mm 3 pcs

To make a table, you need a tabletop of your choice and three table legs of the same length. (In the model picture, the diameter of the table top is about 40 centimeters and the length of the legs is 50 cm).

A round stick with a diameter of 21 millimeters, a pipe, etc. can be used as legs. 
 

The upper end of the table legs can be beveled to a 15-degree angle if you wish (it works without it), the lower end of the legs must be cut straight (the ends of the legs have a 15-degree bevel inside).

The leg holder attached to the table top has places for three fixing screws (pre-hole is 3 mm x 15 mm), you should put a little glue between the table and the bracket in addition to the screws.

The holder for the table legs should be printed without supports and with 50% infill.
The ends of the legs should be printed without supports and with 15% infill.