Hộp (case) Arduino UNO kèm Ethernet Shield

For a little project with use of an Arduino UNO with Ethernet shield I needed a  small but strong case which should be fixed with a Ø31mm magnet.

Because I could not find an Arduino UNO case which also can hold the Ethernet shield I created this one.

Hardware used:

• Aquino UNO
• Ethernet Shield W5100
• Magnet 25kg Ø31mm
• Barrel jack connector Ø11mm
• Some M3 screws and nuts in different length

Printing instructions:

• 0.3 draft profile
• No supports needed
• No brim needed
• Textured sheet used

Happy printing =)