Khay giữ USB TF micro SDcard (Vase Mode) – USB TF micro SDcard Holder

USB, TF, micro SD, SDcard Holder using Vase mode (Spiralized outer contour in Cura).

Holes for mounting are 3mm.

This is a remix of

https://www.thingiverse.com/thing:4499792

which is a remix of

https://www.thingiverse.com/thing:2835728

Print Settings

Printer:

Geeetech E3D V6

Rafts:

No

Supports:

No

Resolution:

0.28mm or less

Filament: Generic PETG or PLA-F or PLA

Any

Notes:

You may need to increase line width from standard 0.4 to 0.5 +5% to 10% flow or 0.6 +10% to 20% flow to get a tighter fit depending on your printer tolerances. you can test using test piece.

Base plate is 1.4mm thick and needs initial layer and bottom thickness to be this size.

check you bottom layer count to make sure it is 1 less then the start of vase or spiral contour layer (if vase starts at layer 6 you want 5 bottom layers)

I used 0.28mm for my initial layer and layer height. 5 bottom layers

Category: Computer