Ngôi nhà ma giữa nghĩa trang với kỹ thuật in filament

Graveyard Mansion - HueForge.

Printing instructions:

Filament swaps ONLY, no MMU or AMS required.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm.

You can use same filaments as I did, or you can experiment with your own.

Don't forget to upload a make!

Filaments Used:

• PLA BambuLab Basic Black Transmission Distance: 0.6
• PLA BambuLab Basic Blue Gray Transmission Distance: 3
• PLA BambuLab Basic Jade White Transmission Distance: 4

Swap Instructions:

• Start with Black
• At layer #4 (0.36mm) swap to Blue Gray
• At layer #16 (0.84mm) swap to Jade White for the rest.