Mount FT Bento Mini dùng FT Panel Clips (Voron V0.2)

INTRODUCTION

This is the Voron V0.2 mount updated to use FT Panel Clips. This means that there is no need to disassemble the Voron V0 printer to insert the M3 hex nuts used to secure it to the bottom extrusion.

INSTALLATION

1. Connect the Bento Mini to the updated FT Bento Mini mount using the 2 x M3x6 BHCS screws.
2. Pre-load the 2 x 1515 keys into the mount.
3. Align to the bottom extrusion and lock in place.
4. DONE!

If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :) 

Should you have any questions you can reach out to us via Discord