Adapter Festool Plug-It cho máy chà nhám DeWalt (DWE6411/DWE6423)

The change is reversible. Fits DWE6411, DWE6423 and other variations.

The model has tight tolerances so you printer and filament should be well calibrated. Also it requires a bit of sanding or cutting to achieve a good fit. It's not possible to make a good fit part for injection molded tool frames - they vary a bit, so grab a sharp knife and a small file and make it fit perfectly.

BOM:

• Festool replacement part # 489742 or # 489925 or whatever number you find it
• Two M4 12mm bolts

Printing settings:

• PETG
• 0.2mm layer height (the model is optimized for this layer height)
• 4 walls
• 100% infill
• Manual tree supports (please see photo of surfaces which needs to be painted/supported)

Installation instructions:

• Disassemble the tool, disconnect and remove the cable
• Dry fit the model, adjust it when needed to ensure that it fits snug but doesn't push the frame apart
• Insert Festool part. Once you insert it you won't be able to easily take it out.
• Screw the bolts, there are no threads in the model so the bolts will be tight
• Trim the cables and crimp them if the cables don't fit well (for DWE6423 they were too long so I had to trim them)
• Connect the cables
• Screw in the connector
• Assemble the rest of the tool