Document Case – Case đựng tài liệu dạng cuốn (in TPU)

This is a simple case which is printed in TPU 80A
 

Note: To get texture as on photo - use some textured PEI plates, be careful as TPU loves to stick too much. For best texture - don't recommend using glue or any other bed-protecting adhesives, just take it off the bed slowly

Version 1: 
needs to be stitched afterwards
also folds need to be heated with a heatgun to keep folded orientation

Current Problems:

* Folds need to be heated, otherwise it tries to open the document
* Needs post processing
* A bit too thick

Roadmap:

Version 1.1:
add cuts to folding lines for easier folding

Version 2 (WIP): 
add metal or printed support material plate mid-print insert (or just print support), to make side pockets in correct orientation

Version 3 (WIP):
Print In Place case