
Băng đạn Talon nghiêng P-SAT Slim Extra Long
Remix of P-SAT: Băng đạn Slim Angled Talon có thể in 3D (Printable) By Zharatos_343050
- Downloads
- 72
- Likes
- 25
- Views
- 517
- Remixes
- 0
- Comments
- 0
Files 2 509.6 KB
- Extra_Long_P-SAT_Body_-_Adjusted_Catch_1777682225.stlSTL · 288.6 KB
- Extra_Long_P-SAT_Body_-_Adjusted_Catch_1777682226.3mf3MF · 221 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #361620
- Category
- Đồ Chơi Khác
- Published
Description
I liked the idea of the original P-SAT, but I had two issues with it. First, the catch hole was too low for the Nightingale and Venom Pro. Second, it wasn't long enough for me. So I fixed both. This is designed to print on my P1S, so anything with a bed volume of less than 256x256x250 will need to cut a section off of the bottom for it to fit (don't attempt to scale it). As is, with a drum spring you can expect a capacity of 24 darts, 25 if you're fine with some squish. You'll probably need to lubricate the follower to get it to feed smoothly. I used thin silicone oil.
The model is pre-oriented, you just need to add supports. Alternatively, you can use the 3mf file which contains the supports that I found to work on my machine. They might be overkill, I was just tired of failures with my initial minimal support tests and may have overcompensated.
You'll also need to print the base and follower from the original P-SAT.
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 509.6 KB
- Largest file
- 288.6 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-
New -

-

-

-

-

-

