Chân đế cao 75mm cho Cooler Master NR200 Mini-ITX

I wanted taller feet to keep the underside air intake further away from the carpet so I made these. Printed in matte white PLA, .2 layer, 100% infill, they look good and feel plenty strong enough. Left and right feet are joined for slightly more strength and ease of fitting, also to provide a ridge to lift with* 

Four M3 brass heat-set inserts go into the print, and these are fastened with M3 screws, though not pan head, I had countersunk but flat head would work.

*I use this on the front of the case and two wheels on the back (model). Four wheels might be too mobile but it is nice to lift the front of the case and then wheel it forward to access rear ports.