Ngàm gắn vỏ (Body Shell Mounts) cho Tamiya TT02

Tamiya TT02 Body shell mounts,

I got fed up with the wobbly originals and didnt fancy buying metal ones that will get abuse and likely bent, so designed some that can just reprint when they get broken

Required

4x 8mm Countersunk posi head screws (replaces the long plastic splitting originals) 4x M3 washers 1mm drill bit and dremel or similar

once printed take the drill to the pilot hole for the screw and mill till you hit the infill of through, careful to use your drill at lowest speed so not to melt it but mill it!

Mine are in CF PETG 237'c 80'c 50mm .5 noz .3 layer 50% infill Gyroid about an hour for all 4 printed at once

large for rear small for front!

Category: R/C Vehicles