Skip to main content
F3D
Vỏ đựng viên nén Storz and Bickel Mighty (OG+PLUS) 1

11 images

DIY

Vỏ đựng viên nén Storz and Bickel Mighty (OG+PLUS)

By Aiirik

Downloads
129
Likes
13
Views
1,469
Remixes
1
Comments
4

Files 4 4.8 MB

  • SB-Mighty-Capsule_Dispenser_Case_V1_1766390657.stlSTL · 2 MB
  • S_B-MightyPlus-Capsule_Dispenser_Case_V1_1766390658.stlSTL · 1.8 MB
  • SB-Capsule_Dispenser_Lid_V1_1766390659.stlSTL · 929.9 KB
  • Capsule_1766390660.stlSTL · 52.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

Hey!

This is a dosing capsule dispenser case combo that was modeled and inspired from the Mighty case which I completely recreated his case model from scratch. (https://www.thingiverse.com/thing:4658819). But with the added dispenser based on a model I have created. (https://www.thingiverse.com/thing:6087060).

The dispenser holds 5 capsules inside and when you pop a used one in, a new fresh one pops out the other end. So you ideally need 6 capsules to make it function properly (5 in the dispenser and one in the Mighty, when one is used, you pop it in the dispenser and new one will come out). Or you can print some mock capsules (file included) to use as a filler or to separate your used caps with your new caps.

_________________________________________________

Future plans:

  • Figure a way to make it more sleek.
  • Improve model with user feedback.
  • Make a Mighty+ Version - Done 15-Aug-2023
  • TBD

_________________________________________________

Versions:

Mighty (OG)

  • V1 - Initial Release.

Mighty (PLUS)

  • V1 - Initial Release. UNTESTED! Please let me know if there's issues

_________________________________________________

Print Instructions:

Dispenser Case

  • Print on its base.
  • Enabled supports for the edge that holds the lid. (so supports required for the hinge part)
  • I printed at .2 but you can change to any quality you want.
  • 4 Walls
  • Infill 35% (again, do as you wish)

Lid

  • Print on its side! (This is to make it stronger so it doesn't break when it snaps shut. You can test printing upside down so the top is flat on the build plate, but I did not test.
  • Enable supports (make sure the supports are properly supporting the hinge part)
  • I printed at .2 but you can change to any quality you want.
  • 4 Walls
  • Infill 35% (wont matter much)

Capsules (Optional)

  • Print as many as you require. They are not needed but I like have 1 separator, so I know when I'm out of new capsules and the used ones don't get mixed. prevents having to open a capsule to double check.
  • I printed at .2 but you can change to any quality you want.
  • 2 Walls
  • Infill 10% (Triangle infill, or as you wish)

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
4.8 MB
Largest file
2 MB

4 comments

See all