Giá giữ mũi & ốc nam châm DeWalt (phiên bản ToolConnect)

Liked the idea of a magnetic holder for screws, nuts, bolts, and bits, but the initial models I printed were both too small and did not fit well with the contours on the side of my DeWalt DCF845 driver (ToolConnect model). So remixed this Dewalt magnetic bits/screws holder by Alexandre M. by increasing the overall size, offsetting the mounting point slightly, and removing one of the “bumps” on the back of the model so that it would fit nicely with my tool. So much room for activities!

Should fit up to 6 total 12x3mm magnets, I ended up gluing smaller 3 mm thick magnets as that was what I had on hand. Right and left versions for using on the right or left (pictured) sides of the driver.