Cửa gió cửa (Door vent v2) 100x300mm

Face is 1.5mm in height and 10mm offset, rear side is 15mm. Doors should be at least 30mm thick. Dimensions are 120x320mm, cutout should be 100x300mm. Can be printed in one piece or two pieces and then glued together. I have Ender 3 so i made a bit smaller version which can be printed side by side at one time if you don't use brim or raft (95x300).  I printed it without raft/brim and it ended up fine, I've printed 4 of them (2 pairs) so far and didn't have any issues. v2 is a bit thicker and without support in the middle, but it has same dimensions. It can only be printed on bigger printers.