Hộp đựng chỉ nha khoa (Placker dispenser)

The challenge I had was that my plackers comes in a plastic bag packaging which is hard to store in my bathroom cabinet and risks falling out whenever I open the cabinet doors. The idea is to create a convenient dispenser thus eliminating the problem.

There is an opening for dispensing plackers by lifting the lid a few millimeters and then shaking the dispenser.

I created a tall version (about 80mm) with the goal of being able to fit a whole pack but if I would print another one I would make it half the height (about 40mm). I have attached both versions here and see other future improvements. After using this for a few days I already see some improvements I would like to include.

• a solution in the lid to make sure plackers stay in place while shaking the dispenser
• an opening for pushing plackers out of the dispenser with your finger.

Attaching the fusion file for anyone who wants to iterate on the concept.

Also attaching the gcodes I had for my prusa mini with PLA but again, I would make the smaller one and possibly some improvements listen above.