Adapter bit (1/4" & 4mm) cho Parkside Cardless Screwdriver 4V PASD 4 B2

Print with Brim and 100% infill. I used carbon filled PLA.

Optionally add magnets (6mm diameter, 3mm height):

1. Standard size (¼") bit adapter:
   Insert the magnet after print. There is a press fit slot inside. Push hard to get it in.
2. Mini size (4mm) bit adapter:
   Insert the magnet mid print. Using Prusaslicer in the preview view move the slider on the right side to 16.2mm. Ctrl-Left click on the + icon and select “Add pause print (M601)”.
   When the printer pauses (right before it begins the selected layer), place the magnet in the bit adapter. You might need to use some glue to prevent the magnet snapping onto the printhead.
   Resume and finish the print.