Móc chìa khóa Swiss key holder 2.0

My previous version (v1.0) of key hoder was alright, but had some design flaws and mainly, since then, I discovered the allmighty threaded inserts. So the goal was clear - make the model from scratch, more design consistent and get rid of the nuts. The result is Swiss key holder 2.0

Print instructions

• Printed in PLA, but any material should do
• No supports needed
• 3MF and gcode are double color
• 30% infill
• 3 perimeters
• Ironing recommended

Additional hardware needed

• 2x M3 threaded insert
• 2x M3 screw 10-20mm (depends on number of keys (M3x16 for 8 keys))