V2 Kẹp 100% Printable – Không chỉ dùng cho nipple! :)

After the initial version garnered significant popularity, I have now taken the opportunity to update and enhance the 100% printable clamp.

What's new?

• Reinforced design
• Simplified thread for easier printing
• Reduced total length

How to print?

• Clamp - Seam position: Random.
• Print at a moderate speed (for the thread).
• Enable 'Elephant Foot Reduction' for the initial layer.
• Chooce PETG over PLA on the clamp.
• There are 2 body-versions and various clamps - you only need 1 of each.

Are you experiencing issues with the thread?

• Attempt to print the threadnut approximately 4-5% larger in the X and Y dimensions.
• Heat the threadnut slightly with a lighter, then screw on the bolt.
• Use a knife or file to clean the thread.

Verify the positioning:

Take a look at the different designs of the clamps.