Cô Dâu Đầu Lâu cho Vase Mode

🤷♂I remixed this from @PeterFarell's Skull Bride to be able to print in Vase Mode. 

Was a little worried about all the sharp edges, but it printed perfectly. I did further deal with some overhangs using Orca's “Make Overhangs Printable” feature, just in case.

Printed with the following settings:

• Layer Height: 0.15mm 
• Line Width: 0.7mm 
• Precise Wall: On
• Arachne
• Make Overhangs Printable: On
• Bottom Layers: 5 (just because 🤷)