Đế sạc/giá đỡ Fitbit Inspire 3

I designed this charging stand/watch holder for the Fitbit Inspire 3.

This was made using Adobe Illustrator for the sketches and TinkerCAD for the modeling. Credit goes to @PRINTSY and their Modular Watch Stand for the inspiration. 

The goal was to fit the charger in nicely while displaying the watch and hiding the cable. 

Printing Details

• The original design is quite difficult to get the USB through, so I uploaded version with a slot cut-out. Note: the version with the slot has not been tested!
• I used 6% honeycomb infill in Orca slicer, which gave me just the right size hexagon to insert some nuts mid print to weigh the base down. Also added some superglue to prevent them rattling. I fit 17 nuts.
• There are 2 versions of the base: one flat, and one with slots underneath for 1cm diameter felt pads. 
• It was designed to avoid supports as much as possible, but they are still needed. 

Stand pictured is Polyterra Satin Purple PLA+ and Eryone Marble PLA