Chậu Cây LEGO Planter

This is a custom planter based on the LEGO 2x2x2 crate, it's as dimensionally accurate as I could get to an actual piece, just much larger and perfect for succulents. The catch tray is custom and friction fits under the planter if you have good tolerances. I do not own any rights to LEGO or the design of LEGO bricks, this is purely for non-commercial use and enjoyment. 

The print shown was on an Artillery Sidewinder X1, printed at 0.2 mm layer height on a 0.6 mm nozzle. I used the PolyTerra PLA in Grey by Polymaker. The walls are thick due to scaling, but I would recommend using 3 outer walls and 5 top surface layers to prevent water leaking.