Giá đỡ tablet và điện thoại (printed in place)

This is a simple tablet and mobile phone stand printed in place. 

NOTE: The FreeCAD file is available if you want to change the hinge tolerance of change the model

Print Time

• Open 1mm → Prusament PLA, 15% infill, 0.20mm SPEED =~ 38 min
• Close 1mm → Prusament PLA, 15% infill, 0.20mm SPEED, Brim, Support on build plate only =~48 min

Version 2 improvements

• FreeCAD spreadsheet with parametric value to configure the hinge tolerance
• Chamfered on both sides, 1.2mm on each

Available Print shapes

1. Opened
2. Closed

V2 Hinge Tolerance (New)

• 1mm, 0.5 on each side
• 0.9mm, 0.45 on each side
• 0.8mm, 0.4 on each side
• 0.7mm, 0.35 on each side
• 0.6mm, 0.3 on each side

V1 Hinge Tolerance (Old)

• 1 mm, 0.60 down and 0.40 up side of the hingle
• 0.7 mm, 0.35mm on each side of the hingle
• 0.3 mm, 0.15mm on each side of the hingle