FlamoVase

You can scale larger (or smaller) from the 100mm (~4") version.  Stretching in Z only, taller or shorter, yields some interesting versions. 

This is the first in a series of twisted shapes but this one has a unique flame flavor, so stands alone in name. It can be printed in single wall vase mode, no top layer, or set up like single layer but turn off single layer mode and use 2 wall layers 3-5 bottom layers and no top layers which I did with the three color example. In the three color example I hit pause while on the inner layer which helps get the flow going again and avoids noticeable defects on the outer layer. 

This design also makes a nice bowl by stopping the print (or just slicing) at a lower layer, like 50% though 80%.

If you stop your print at about 30% of its full height, it makes a great screw on lid for the full print of the same scale. See the photos.

Category: Sculptures