Rơ-moóc sàn phẳng (Flatbed Trailer) tỉ lệ H0 1:87

This is a h0-scale flatbed trailer I designed for my Carson 1:87 RC Unimog (great toy, proportional RC in a 1/87 Unimog!).

Print Settings

Printer:

Ender 2

Rafts:

No

Supports:

No

Resolution:

0.1

Infill:

15%

Filament:

Doesntmatter PLA

green for the bed, black for the chassis, red for the rims. Or whatever you fancy!

Notes:

Make sure your printer is well set-up and calibrated, this thing is smaaaalll!

Post-Printing =============

Assembly

Put the front axle on the chassis plate, push one of the three pins in the hole (They differ slightly in diameter, you may have to use pliers to push it completely in)

Fit tow-bar to the front axle.

Get some TJet tires or print tires from TPU: Inner diameter 4,8mm, outer dia 10mm, 2mm wide. Use small nails as axels.

After assembling the chassis, glue the flatbed on top of the chassis. Look for the hinges, the short side with no hinges on the bed face to the front.

Get an RC Unimog and enjoy! You can even hook one trailer behind the other.

Category: R/C Vehicles