Núm cần số cho Thrustmaster TH8S (không cần adapter)

So i modeled a shifter knob for thrustmasters new th8s shifter

i noticed that there was none of these on the internet, i only found adapters and almost none shifters that fit on the adapters, so i decited to make my own

it just slots into the shifter slot and uses the original shifter knob screw, so there is no adapter needed

there are 3 files, 12mm one is the one with a big hole on the top for bigger screwdrivers and the 8mm for smaller ones, the screw just fits in so make sure the printer is calibrated, there is also one with no hole because it goes in very tightly on its own too good for people who dont have long torx screwdrivers

i made mine out of pla, petg would be stronger

15% infill

0.20mm quality

no supports

and a brim

everything is made on a ender 3, so you dont need no fancy printer for this