Skip to main content
F3D
Bảo Vệ Mối Nối Dây Nguồn (Bản Cập Nhật) 1

4 images

Đồ Gia Dụng

Bảo Vệ Mối Nối Dây Nguồn (Bản Cập Nhật)

By vidision

Downloads
181
Likes
181
Views
2,250

Files 3 4.3 MB

  • Power_Cord_Cover_1777431893.stlSTL · 1.6 MB
  • Power_Cord_Cover_-_Long_Gasket_1777431895.stlSTL · 1.5 MB
  • Power_Cord_Cover_-_End_Plug_1777431896.stlSTL · 1.2 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Print in TPU! 

(It has to be flexible in order to fit over a cord/plug.)

Check dimensions first. Resize Z is an option.

While this is NOT meant to be waterproof, I did add a long gasket and end plugs to make it a bit more tightly enclosed.

I iterated this a few times and ended up narrowing the cut along the side. On my last print, there was occasional stitching/spaghetti between the two sides that I cut with an xacto blade. Because this is a functional item, I'm not worried about the aesthetics, but if you are … you may want to do a partial print or calibrate your TPU or add a negative to widen the slot.

My settings:

  • Vertical, no supports
  • TPU 95A
  • 0.28 layer lines
  • 2 walls
  • 5% gyroid infill (this is very minimal, you may desire more for strength/durability)
  • Outer brims on

The gasket and end plug used the same settings. It was important to turn on THIN WALL DETECTION, because the end plug is a very thin (flimsy) single wall cylinder. As such, I left it to print intact and then cut it with scissors after printing.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
4.3 MB
Largest file
1.6 MB

0 comments

See all