Skip to main content
F3D
Holder gập cho Hex Wrench/Allen Key (Metric & SAE) 1

4 images

DIY

Holder gập cho Hex Wrench/Allen Key (Metric & SAE)

By cwennet_340085

Downloads
215
Likes
27
Views
1,374

Files 13 22.5 MB

  • Allen_Key_Holder_Metric_-_V1_1777425433.stlSTL · 920.3 KB
  • Allen_Key_Holder_Metric_-_V1_1777425434.f3dF3D · 2 MB
  • Allen_Key_Holder_Metric_-_V1_1777425435.stepSTEP · 3 MB
  • Allen_Key_Holder_SAE_Slice_Test_1777425436.stlSTL · 87.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#350367
Category
DIY
Published

Description

3/14/24: Updated the Metric holder: Added a slot for a #12, adjusted the key tolerances to fit more smoothly than the original, and cleaned up the F3d file (However, the F3d still has some issues when attempting to re-adjust keyhole diameters).

-------------------

Foldable Hex Wrench / Allen Key Holders: 

  • Metric holds 14 keys
  • SAE holds 13 keys

This is modeled after the foldable holder that came with my Wera Hex Plus sets, which only hold 9 keys each. I wanted something similar to hold all of the sizes that I have.

Please Note:

  1. Tolerances are tight.  I printed with a .6 nozzle at .2 layer height.  Test prints with the same nozzle and .3 layer height had slightly different results.  I suggest using the “Slice Test” files first to dial in your printer before printing the final holders.
  2. Holders are printed in TPU with 100% infill for extra rigidity (and also in case of the need for very slight carving adjustments with an Xacto Knife). I printed horizontally and used supports.
  3. Latch should use a rigid filament like PETG.  No supports are needed if printed vertically. It is small - 100% infill does not use much filament.
  4. Fusion 360 and/or STEP files are attached in case you need to make adjustments.

Read more Show less

Print spec

Formats
f3dstepstl
Model files
13
Total size
22.5 MB
Largest file
5.3 MB

0 comments

See all