Skip to main content
F3D
Mô hình trang trí cây thông Noel "Flying Cock" 1

13 images

Mỹ Thuật

Mô hình trang trí cây thông Noel "Flying Cock"

Remix of Dương Vật - Dương Vật thật được scan 3D By Kuna

By ___Sam____346761

Downloads
286
Likes
223
Views
3,937

Files 4 5.2 MB

  • wings_1777419232.stlSTL · 1.5 MB
  • shaft_1777419233.stlSTL · 1.4 MB
  • shaft_with_modifier_1777419234.stlSTL · 1.5 MB
  • flying_cock_1777419235.3mf3MF · 858.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Whats more festive than a flying cock in your Christmas tree!

Like and subscribe for other grown up ideas….

Print instructions 
-Shaft
there are two ways to print the shaft, i didn't have much of the pink filament left so i printed it hollow, and filled it with rice as the shaft has to be heavier than the wings for it to hang properly. 
to make a hole in the model to put rice in use the included modifier which makes a hole where the wings attach so this is sealed up when you add the wings. 
settings - 2 perimeters, 0,2mm layer height, with brim, 15% lighting infil 
set modifier settings to 0 top/bottom layers and 0 perimeters 

Or you can print it solid as per normal but it would need enough infil to add a bit of weight. 

-wings 
These have carefully been made and oriented so that they can be printed without support. 
But depending on your print quality you may benefit from them, it only adds 20 minutes in my slicer.  If not using supports a brim might be required. 
Mine are printed at quite a small layer height to preserve the detail of the wings but im not sure how required that is. 3 perimeters for strength, and avoid crossing perimeters will minimise stringing. 
 

Assembly 
Slowly add rice to the hole tapping as you go until no more will fit, push the wings into the matching hole, it will hold itself in but its designed to be secured with a bit of superglue for simplicity. 
Cut a length of sewing thread and use it in the eyelet hidden between the wings.

Read more Show less

Print spec

Formats
3mfstl
Model files
4
Total size
5.2 MB
Largest file
1.5 MB

0 comments

See all