Bao da cứng cho Airtag của Apple

A simple case for a single Apple Airtag, with an opening at the top for a keychain or other loop. Held together by four M3 screws, which thread into the plastic on the bottom piece itself. Anything longer than an M3x8 will stick out in the back, which is not ideal.

Be sure to print with the outward facing sides down on the build platform.

Four M3x8 screws are required.

Print Settings

Printer Brand:

Prusa

Printer:

MK3S

Rafts:

No

Supports:

No

Resolution:

.2 mm layer height

Infill:

15

Filament: AmazonBasics PLA Blue

Category: Keychains