Ngàm gắn GoPro cho DJI Avata (Quick Release)

A quick-release go-pro mount for the DJI Avata. We printed ABS with 3 perimeters and 15% infill on the Prusa Mini, which seems to hold up well to being attached/detached. If we reprint, we'll likely increase the perimeter count. 

To add/remove from the avatar, clip into the triangular holes just below the “DJI” emblem on the Avata. Insert one side, then bend and push the other side down onto the drone. The mount should be a friction fit with no movement forwards/backwards. 

To remove pull out and up on one side until you can pull tab above the top of the drone. Mount then is detached.